User Manual

ManualsBrandsSenal ManualsLarge Diaphragm CondenserLarge-Diaphragm Cardioid Condenser Microphone

Table of Contents:

Introduction �� 2

Overview ��3

Precautions ��4

Mounting the Microphone �� 5

Positioning the Microphone ��6

High-Pass Filter ��6

Attenuation Pad ��6

Connecting the Microphone �� 7

Troubleshooting �� 8

Speciﬁcations ��9-10

Warranty �� 11

USER’S GUIDE

SCM-600

Summary of content (12 pages)

PAGE 1
Table of Contents: USER’S GUIDE Introduction�� 2 Overview �� 3 Precautions ��4 Mounting the Microphone �� 5 Positioning the Microphone ��
PAGE 2
Thank you for choosing Senal. The Senal SCM-600 is a professional-grade, large-diaphragm, true condenser microphone. Its 1.3″ gold-plated transducer element is designed to give detailed and accurate sound reproduction in studio applications. Its full, rich tone and clarity make it an ideal microphone for studio recording, broadcasting, podcasting, or live recording. With a wide dynamic range and high SPL of 140 dB, this microphone captures vocals and instruments accurately and with pristine clarity.
PAGE 3
Overview Shock mount 1.
PAGE 4
Precautions ▪ Please read and follow these instructions and keep this manual in a safe place. ▪ Exposure to high sound levels can cause permanent hearing loss. Avoid listening at high volumes for extended periods. ▪ Keep this product away from water and flammable gases or liquids. ▪ Do not attempt to disassemble or repair this product yourself. ▪ Handle this product with care. ▪ Clean this product with only a soft, dry cloth.
PAGE 5
Mounting the Microphone To mount the SCM-600, follow these steps: 1. Screw the included shock mount onto a 5/8″ threaded microphone stand and make sure it is in a 90-degree position. Then fully tighten the locking knob on the shock mount. 2. Carefully place the bottom of the microphone into the shock mount. Screw in the shock mount thread from below the shock mount and tighten it until secure.
PAGE 6
Positioning the Microphone The SCM-600’s cardioid polar pattern picks up sound mostly from in front of the microphone. The front of the microphone (the side with the Senal logo) should be facing the sound source, although it is important to experiment with microphone placement and positioning to find the best solution for your specific recording.
PAGE 7
Connecting the Microphone Use an XLR cable (not included) to connect the microphone to your mixing console, microphone preamp, or recording device. Make sure phantom power is turned on. Note: Phantom power must be used with this microphone. Make sure your recording device has proper +48 V phantom power. Warning Make sure all faders and volume knobs are turned down. After the microphone is connected, set the volume to your preferred level for recording.
PAGE 8
Troubleshooting Problem Solution No sound is being recorded. Make sure your mixer or amplifier is turned on and phantom power is engaged. The fader of the channel or master volume on your mixing console is turned all the way down. Your preamp gain is turned all the way down. Make sure the microphone is properly connected and connections are secure. Check your cable to make sure it’s reliable. Try switching it with another cable. 8 ▪ The sound is distorted. Turn on the microphone’s attenuation pad.
PAGE 9
Specifications Element: True condenser transducer Diaphragm: 1.3″ gold-plated diaphragm Polar pattern: Cardioid Frequency response: 20 Hz to 20 kHz Sensitivity: -36 dB ±3 dB Signal-to-noise ratio: 76 dB (1 kHz @ 1 Pa) Maximum input SPL: ≥130/140 dB (0/-10 dB pad) (THD ≤1.0% @ 1 kHz) Output impedance: 50 Ω @ 30% Power requirements: 48 V DC phantom power Output connector: 3-pin XLR Pad: -10 dB High-pass filter: -10 dB/octave @ 110 Hz Dimensions (H × Ø): 6″ × 2″ (15.2 × 5.
PAGE 10
Frequency Response Graph Polar Pattern Frequency Response Relative Response in dB -20 0° 330° 30° 60° 300° -30 90° 270° -40 120° 240° -50 210° 180° 150° -60 50 0 100 1K 500 5K 20K 10K Frequency in Hertz 10 ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪
PAGE 11
Two-Year Limited Warranty This Senal product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of two (2) years from the original purchase date or thirty (30) days after replacement, whichever occurs later.
PAGE 12
GG1