User's Manual

9. Connect to the other Bridge

For some special reasons, you may need to install two bridges as a

wireless repeater to lengthen the coverage range. Connect two bridges using a

crossed cable and plug into the LAN2 port in the side panel of the

DC-Converter as shown in Figure 2-2. Refer to the Chapter 3.3 for creating

two of Bridges as a wireless repeater.

10. Antenna Alignment

In case Bridge A is connecting with network IP 192.168.123.100. Bridge

B is connecting with network IP 192.168.123.101.

1. Figure out the rough direction/ location for both of the communication

stations A and B by map finding or by experience in using GPS/

compass/ telescope first!!

2. Connect both station stations A and B, roughly fix the Antenna and

pointing to the station direction for each other.

3. In DOS Mode, Ping A computer to B computer. (command ：ping

192.168.123.101 –t ).

4. Stay B ANT. in the same direction, Fine tune A Antenna only with small

angle (less than 5 degree) in up/down/right/left direction, please check

the result of IP being ping, make sure the system in linking condition as

well as the time out possibility and response time as low as possible, if

the system been tuned to this condition, it is time to fix the A Antenna.

5. If the A Antenna has been fixed, please tune and fix the B Antenna

according to procedure 4. (Command for B computer to Ping A

computer: ping 192.168.123.100 –t).

6. If the link quality and the signal strength not in reasonable performance,

please repeat step 4 and 5 until optimum condition.