User's Manual

is the normal operation mode of a Bridge. Users can change it to the “AP ”

mode if you want this product to work as a wireless access point.

Figure 4.4

3.Network ID (SSID): Network ID is used for identifying the Wireless LAN

(WLAN). Client stations can roam freely over this product and other Access

Points that have the same Network ID. (The factory setting is “default”).

Note: This item won’t take effect in “Bridge ” mode.

4.Channel: The radio channel number. The permissible channels depend on the

Regulatory Domain.

The factory setting is as follows:

Countries Channel

USA/Canada 1 - 11

Europe/Australia (ETSI) 1 - 13

Japan (All) 1 -14

Singapore, France 10 - 13

Israel 3 - 8

5.WEP Security: Select the data privacy algorithm you want. Enabling the

security can protect your data while it is trans ferred from one station to

another. The standardized IEEE 802.11 WEP (64-bit or 128-bit ) is used here.

6.WEP Key 1, 2, 3 & 4: After enable the 64-bit or 128-bit WEP key security,

please select one WEP key to be used in default setting and then input 10 or 26

hex-decimal (0-9, A-F) digits.

7.MAC Access Control: Setup MAC addresses to control which wireless

clients can associate to the wireless LAN and this device or connect to this

device.