User's Manual

31
Chapter 5 System Troubleshooting
Problem and Indication Possible Solution/ Answer
What is this bridge’ s default
IP Address?
This bridge’ s default IP address is 192.168.123.254
I reset this bridge to factory
defaults but the IP address
hasn't changed.
Resetting this device to factory defaults does not
reset the device's IP address to 192.168.123.254
I can't exchange data over a
Point to- Point link.
Check the following steps:
1. Ensure that each device has the same Channel
and SSID.
2. Confirm that both devices have Bridge Mode
enable.
3. Make sure that all obstructions and possible
sources of interference were considered when
designing the path.
Lots collisions on my
network have increased
dramatically after I installed
this device?
If these devices in your installation have a poor
radio link, then this can increase the number of
collisions on the network. Improve the radio link
between each device to reduce the number of
collisions.
What antenna should I use
with this bridge?
This device does not ship with an antenna. You
should order an antenna additionally. Antenna
selection depends on the requirements of your
microwave path. Refer to the Table 3-1 to get the
recommendation of the antennas.
I can't ping a remote site
from across the wireless link.
This device is only valid over the Ethernet interface
and will not respond to ping requests from across
the radio link.
No Power to device, Power
LED is off.
1. Power cord is not properly connected. Please
verify power cord to connect to this device and to
the power outlet.
2. Power supply is defective. Please replace the
power supply.
Wireless link has established, 1. Check that the LINK LED is lighted Green. If