User Manual
Table Of Contents
- Contents
- Chapter 1 Introduction
- 1- 3 System Requirements
- 1- 4 Features and Benefits
- 1- 5 Applications
- 1- 6 Network Configurations
- Chapter 2 Installing Drivers & Client Utility
- Chapter 3 Connecting to a Network
- Chapter 4 Troubleshooting
- Appendix AProduct Specifications
- Appendix B
- Regulatory Compliance Information
Appendix B
Regulatory Compliance Information
Radio Frequency Interference Requirements
This device complies with Part 15 of FCC Rules and Canada RSS-210.
Operation is subject to the following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.
3. To comply with RF safety requirements, you must maintain a distance of 20
cm from the antenna when operating the device.
4. This transmitter must not be co-located or operating in conjunction
with any
other antenna or transmitter.
5. Since the module is installed inside the end product, the end product should
be affixed a label on visible area showing that this product contains a RF
module, and also its FCC ID.
Interference Statement
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules, These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, (example – use only
shielded interface cables when connecting to computer or peripheral
devices). Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to
27