User Manual

High-Speed Wireless Cardbus Adapter Version: 1.1
Page 12 of 28
9. The installation of the PC card is now complete. Click on the Finish button.
2.3 Verify the installation
Follow the steps below in order to verify that the PC card has been installed and is
functioning properly:
1. Click on Start > Settings > Control Panel.
2. Double click on the System icon.
3. Click on the Hardware tab, and then click on the Device Manger button.
4. Select Network adapters to view a list of network adapters on your PC. You
will then see a window similar to the image below.
5. Make sure that you do not see a yellow (?) or a red (X) next to the PC card
(IEEE 802.1g WLAN 11g network adaptor 802.11g Adapter). If you do see a
(?) or (X) you would need to uninstall the drivers, and reinstall them again. In
order to uninstall the drivers refer to section 2.6 Uninstall Client Utility.
2.4 Disable Windows SSID/WEP Configuration
In order to configure SSID and WEP settings from the Client Utility, you must first
disable the Windows based SSID and WEP configuration from the Network