SENAO International SI 7800B AP Simple Manual 第 1 頁，共 17 頁
SENAO International 1. Understanding the Hardware 1.1 Hardware Configuration RJ-45 Ethernet Connector – Provides 10 Mbps connectivity to a wired Ethernet LAN. Reset Button – By holding this down for more than 3 seconds, the unit will reset to its factory default settings. Power Supply Connector – Connects to the power adapter. 1.2 Hardware Installation A. Configure your notebook or PC with a wireless LAN card. B.
SENAO International 2. System Consists of Administrator Settings、Firmware Upgrade、Reset、Restore Defaults 1.
SENAO International 2. Firmware Upgrade step 1 step 2 Click Browse to find new Firmware，then click save and restart 3.
SENAO International 4. Restore Defaults Click Restore Defaults 3. LAN Consists of LAN Settings、DNS Settings 1.
SENAO International 2. DNS Settings Enable DNS Relay Service，change Domain Name Suffix and Primary Domain Name Server Address and then click save and restart 4. Services 1. Network Servives Consists of SNMP Server、DHCP Server、System Log Daemon、Easy Setup Wizard A.
SENAO International Read only community , enter public Read write community, enter private After modifications, click save and restart 第 7 頁，共 17 頁
SENAO International B.
SENAO International C.
SENAO International D.
SENAO International 5. Wireless Consists of Settings、Operational Mode、Security Settings、MAC Filtering 1. Settings Click save and restart after change 2.
SENAO International 3. Security Settings Click save and restart after change 4.
SENAO International 6. Information Consists of System Status、Wireless Status、Association List、LAN Statistics、Wireless Statistics、DHCP Client List 1. System Status You can find LAN and System Information settings here 2.
SENAO International 3. Association List You can find what wireless LAN or AP are attached to SI 7800B AP 4.
SENAO International 5. Wireless Statistics You can find Unicast Packets、Broadcast Packets、Multicast Packets here 6.
SENAO International Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
SENAO International IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
