User's Manual

www.snapav.com | Support: 866.838.5052
15
Araknis Networks Wireless Access Point
Quick Start Guide
Step 6. Log In and Complete Setup
A. After connecting to the WAP over WiFi, open a web browser and
enter the configuration address for your device:
• AN-100-AP-I-N use: http://config.an100.wap/
• AN-300-AP-I-N use: http://config.an300.wap/
Note – You can also identify your WAP’s network IP address by using
the DHCP table on your router (for DHCP mode), or by using IP scanner
software. Free IP scanners available online.
B. Log into the device using the default login credentials:
• Username: araknis
• Password: araknis
C. Change the default SSID to the preferred SSID.
Pro Tip – It is recommended to assign static IP addresses outside the
DHCP range to your network devices. Document the IP information for
all devices in a spreadsheet for easier future service.
Pro Tip – The Device Name can be used to login to that device in the
future. For example, you log in to a WAP for the first time using “http://
config.an100.wap”. Then, you change the Device Name from “an100” to
“bedroom”. The next time you want to access the WAP, you can type
“http://config.bedroom.wap” instead of the IP address.
Pro Tip – The Araknis Networks WAP comes defaulted with an open
SSID called “araknis_initial”. This SSID is only for initial setup purposes.
It is highly recommended to change the network name and apply bet-
ter security measures for your wireless network.
Note – For additional setup, see the full manual at www.SnapAV.com.