Manualshelf

User's Manual

ManualsBrandsSenao Networks ManualsElectronicsAraknis Networks 300-series Dual-Band Concurrent Wireless-N Indoor Access Point
11121314151617181920
2.2.1. IP Settings
The IP Settings section allows conguration of the AN100/300 IP Address. In default mode the IP Settings section will show
the DHCP IP Address and default Subnet Mask. A Static IP Address, Subnet Mask, Default Gateway and DNS Settings can be
congured by disabling DHCP.
Figure 16. IP Settings
Path Settings, LAN, IP Settings
Parameters
NOTE: DHCP is the default setting. If a Static IP Address has been assigned, but DHCP is selected, the assigned Static IP
Address (and Subnet Mask) will be shown, (grayed out) and the Dynamic Address will be active. To conrm the active
AN100/300 IP Address, see: System Status screen/LAN Information/IP Address.
• IPAddress– Uncheck ‘DHCP Enable’ to enter a Static IP Address for the AN100/300. Use of a Static (permanent)
IP Address is recommended. If using a Static IP Address be sure the Network Router is congured to allow Static IP
Addresses and that the IP Address used is within the network address scheme. DEFAULT: 192.168.20.253
• SubnetMask– Enter the Subnet Mask for the AN100/300. DEFAULT: 255.255.255.0
• DefaultGateway– With DHCP disabled, enter the Default Gateway for the AN100/300 (Network Router IP Address).
DEFAULT: Network Router IP Address
• PrimaryDNS– With DHCP disabled, enter the Primary DNS for the AN100/300. This will typically be the Network
Router IP Address. DEFAULT: 0.0.0.0
NOTE: The Primary and Secondary DNS Addresses are required when setting up a Static IP Address.
• SecondaryDNS– With DHCP disabled, enter the Secondary DNS for the AN100/300. This will typically be the Network
Router IP Address. DEFAULT: 0.0.0.0
NOTE: The Primary and Secondary DNS Addresses are required when setting up a Static IP Address.
• DHCP– Select to allow automatic assignment of AN100/300 IP Address via the Network Router. De-select to allow
conguration of a Static IP Address. Use of a Static IP Address is recommend for this device. DEFAULT: Enable.
Configuration Instructions
To congure IP Address Settings:
1. Click Settings, LAN.
2. Specify the IP Settings.
3. Click Save.