User's Manual

2.3.2. Wireless Networks
The Wireless Networks section allows conguration of AN100/300 wireless networks (SSIDs), security settings, band steering
and channel isolation.
Figure 20. Wireless Networks
Path Settings, Wireless
Parameters
NOTE:TheWAP100willindicatesettingsandinformationforthe2.4GhzChannel.TheWAP300willindicatesettings 
andinformationforthe2.4GHzand5GHzChannels.
• Enable– Select Yes to turn a Wireless Network ON. DEFAULT: Selected.
• Name(SSID)– Enter the network name for the specic network being congured. DEFAULT: araknis_initial; (Blank
when adding a network).
• Interface– Select 2.4GHz/5GHz or Both Channel Frequency. OPTIONS: 2.4GHz, 5GHz, Both. DEFAULT: Both,
(2.4GHz when adding a network).
• SecurityMode– Congure the Security Mode for each wireless network. Select a Security Mode from the drop-down to
open the Wireless Security Setup Window window.
WirelessSecurity(AllModes)
1. Name(SSID)– The network name of the network being congured
2. SecurityMode– Select a Security Mode from the drop-down. Use the same Security Mode used by the
network router and all other APs on the same network. OPTIONS: Open; WPA2-PSK; WPA2-PSK Mixed;
WPA2; WPA Mixed. DEFAULT: Open
3. Encryption– The Encryption Mode will default to the Security Mode selected. DEFAULTS: WPA2-PSK will
default to AES; WPA2-PSK Mixed will default to Both (TKIP+AES); WPA2 will default to AES; WPA Mixed will
default to Both (TKIP+AES).
4. Passphrase– Enter the appropriate passphrase for the wireless network being congured. If using the
ASCII format, the password must be 8-63 characters in length. If using HEX, the password must be 64 HEX
characters in length. DEFAULT: Blank
5. GroupKeyUpdateInterval– Enter a value to specify how often in seconds the Group key changes. RANGE:
30-3600. DEFAULT: 3600 (60 minutes)
6. Save– Click to save changes to the Wireless Security Settings for this network. The window will close. The
changes should appear as a numeric value on the Apply Changes button. Proceed with setup if additional
changes are required, or proceed to Save/Cancel at the end of this section.
7. Cancel– Click to cancel changes to the Wireless Security Settings for this network. The window will close.
Proceed with setup if additional changes are required.
If using WPA2 or WPA2 Mixed:
8. RadiusServer–Enter the Radius Server IP Address. DEFAULT: Blank
9. RadiusPort–Enter the Radius Server connection port number. This is a dedicated TCP/UDP port and would
typically not be changed. DEFAULT: 1812
10. RadiusSecret–Enter the Radius Server connection secret. DEFAULT: Blank
11. RadiusAccounting–Select Enable to enable Radius accounting. Select Disable to disable Radius
Accounting. DEFAULT: Disable
12. RadiusAccountingServer–Enter the Radius Accounting Server IP Address. DEFAULT: Blank
13. RadiusAccountingPort–Enter the Radius Accounting Server connection port number. This is a dedicated
TCP/UDP port and would typically not be changed. DEFAULT: 1813
14. RadiusAccountingSecret–Enter the Radius Accounting Server connection secret. DEFAULT: Blank