User Manual

9.4. Repeater

Repeater is used to extend the wireless coverage area of the Access Point. Please refer to the

previous section to configure the Access Point.

Repeater

Step1

192.168.1.1

Step2

Select a Radio to change Operation Mode to Repeater from

System -> Operation Mode.

Step3 Select 802.11a/b/g/n as your wireless mode.

Step4

Use site survey to scan nearby Access Point and select the certain

AP you would like to connect with or enter SSID manually.

Step5

Select correct authentication type and password the same as

Access Point.

Note: 1. For more advanced settings, please refer to the previous chapters.

2. Repeater IP subnet must the same as the Access Point, please refer to the IP

Settings section for details.

Wireless Client

Step1 Open wireless client utility software page.

Step2

Use site survey to scan nearby Access Point and select the certain

AP you would like to connect with or enter SSID manually.

Step3 Configure VLAN ID in your wireless device if available.

Step4 Select correct authentication type and password.

Caution: Wireless Client IP address must configure manually at the same subnet in Local Area

Network or enable DHCP server of ECB7510 to retrieve IP automatically.

Access Point /

Wireless Router

ECB7510

Client

192.168.1.1

192.168.1.2

192.168.1.10

192.168.1.11