User's Manual

5 System
5.1 Switching Operation Mode
The ENH200 supports 4+1 operation modes: Access Point, Client Bridge, WDS Bridge, and Client
Router. In order to switching between the operating modes, please go to System -> Operation mode.
Click System Properties under System Section to begin.
.
Device Name: Specify a name for the device. It is not the broadcast SSID. It will be shown in SNMP
management.
Country/Region: United States
Operation Mode: Select an operation mode via Radio Button.
Click Accept to confirm the changes.
Accept does not compile the changes, you must go to Status -> Save/Load to apply the new settings.
Please refer to the chapter 4.1 for more detail.
If you would like to use Access Point with WDS Function mode, please select Access Point Mode and