User's Manual

10 Network Configuration Example
This chapter describes the role of the ENH200 with 4+1 modes. The Access Point mode’s default
configuration is a central unit of the wireless network or as a root device of the wired environment.
Repeater mode and Mesh network mode need future configuration.
10.1 Access Point
Access Point
Step1 Login to the web-based configuration interface with default IP
192.168.1.1
Step2 Follow region’s regulation.
Step3 Use site survey to scan channels that have been used in nearby area.
Step4 Select channel with less interferences.
Step5
Specify the SSID for your broadcast SSID and you can also configure
multiple SSID at the same time.
Step6 Verify VLAN identifier to separate services among clients
Step7 Setup the authentication settings.
Step8 Apply to process all the configurations.
For more advanced settings, please refer to the previous chapters.
Wireless Client
Step1 Select wireless mode you would like to associate with.
Step2
Use site survey to scan nearby Access Point and select the certain AP
you would like to connect with or enter SSID manually.
Step3 Configure VLAN ID in your wireless device if available.
Step4 Select correct authentication type and password.
ENH200’s Access Point Mode does not provide DHCP server so the Wireless Client IP
address must configure manually at the same subnet in Local Area Network.
ENH200
Client
Client
SSID2
SSID1
Ethernet
Client
192.168.1.1
192.168.1.10
192.168.1.11
192.168.1.12