User's Manual

10.4 Client Router
In the Client Router Mode, the ENH200 has DHCP Server build inside that allows many LANs
automatically generate an IP address to share the same Internet. Connect an AP/WISP Wirelessly and
connect to LANs via wired. Client Router Mode is act completely opposite to the AP Router Mode.
Please refer to the last section to check Access point’s configuration.
Client Router
Step1 Login to the web-based configuration interface with default IP
192.168.1.1
Step2 Follow region’s regulation.
Step3 Select Operation Mode to Client Router from System Properties.
Step4 Change your Local Area Network setting to Obtain an IP Address
Automatically.
Step5 Use site survey to scan Access Points that are available in nearby area.
Step6 Select the AP you would like to associate with.
Step7
Setup the authentication settings that match to the Access Point’s
setting.
Step8 Setup your WAN connection type given by your Internet Service
Provider from WAN Settings.
Step9 Press Apply to process all the configurations.
Client Router’s IP setting must match to the Access Point’s subnet.
ENH200
AP / WISP
PC
PC
PC
192.168.1.1
192.168.1.10
192.168.1.11
192.168.1.12