User's Manual
Table Of Contents
- 1 Product Overview
- 2 Installation
- This chapter describes how to install the ENH202.
- Select the optimal locations for the equipment using the following guidelines:
- 3 Wireless Network Modes
- 4 Configuring Your Computer for TCP/IP
- 5 Status
- 6 System
- 7 Wireless Configuration
- 8 LAN Setup
- 9 Router Settings
- 10 Management Settings
- 11 Network Configuration Examples
- Appendix A – Troubleshooting
- Appendix B – Specifications
- Appendix C – Glossary
- Appendix D – Statements of Conformity
1.6 Understanding the ENH202 LEDs
The rear of the ENH202 has two groups of LEDs. One group, labeled INDICATORS, shows the
status of the device. The second group, LINK QUALITY, shows the strength of the link
between the ENH202 and the network. The following table describes the ENH202 LEDs.
LED Color Mode Status
Power
Green
OFF= ENH202 is not receiving power.
ON= ENH202 is receiving power.
LAN
Green(Main)
Orange(Secondary)
OFF = ENH202 is not connected to the network.
ON = ENH202 is connected to the network, but not sending or
receiving data.
Blink = ENH202 is sending or receiving data.
WLAN
Green
Access Point
or Client
Bridge Mode
OFF = ENH202 radio is off and the device is not
sending or receiving data over the wireless LAN.
ON = ENH202 radio is on, and the device is not
sending or receiving data over the wireless LAN.
Blink = ENH202 radio is on, and the device is
sending or receiving data over the wireless LAN.
Link Quality
See Status column
Access Point
or Client
Bridge Mode
Shows the strength of the link between the
ENH202 and the network.
G = good quality (green).
Y = medium quality (yellow).
R = poor or no link (red).