User's Manual
Table Of Contents
- 1 Product Overview
- 2 Installation
- This chapter describes how to install the ENH202.
- Select the optimal locations for the equipment using the following guidelines:
- 3 Wireless Network Modes
- 4 Configuring Your Computer for TCP/IP
- 5 Status
- 6 System
- 7 Wireless Configuration
- 8 LAN Setup
- 9 Router Settings
- 10 Management Settings
- 11 Network Configuration Examples
- Appendix A – Troubleshooting
- Appendix B – Specifications
- Appendix C – Glossary
- Appendix D – Statements of Conformity
5 Status
The Status section is on the navigation drop-down menu. Selecting it, you will then see three
options: Main, Wireless Client List, and System Log. Each option is described in detail below.
5.1 Save / Load
This page allows viewing of the modified settings. The changes will show in the Unsaved
changes list. You can decide to cancel (Revert) all the changes or to Save & Apply the new
settings.
Please make note of the following:
1. You cannot cancel specific settings. You can only save all of the settings or revert to the
previously saved state.
2. You need to use the Save/Reload page to commit your configurations by clicking the “Save
& Apply” button.