User's Manual
Table Of Contents
- 1 Product Overview
- 2 Installation
- This chapter describes how to install the ENH202.
- Select the optimal locations for the equipment using the following guidelines:
- 3 Wireless Network Modes
- 4 Configuring Your Computer for TCP/IP
- 5 Status
- 6 System
- 7 Wireless Configuration
- 8 LAN Setup
- 9 Router Settings
- 10 Management Settings
- 11 Network Configuration Examples
- Appendix A – Troubleshooting
- Appendix B – Specifications
- Appendix C – Glossary
- Appendix D – Statements of Conformity
About This Document
This document is written by EnGenius Inc. EnGenius Inc. the reserves the right to change this
document without notice and all rights are reserved. This document can only be used for the
configuration of EnGenius products.
This document is to characterize the EnGenius ENH202 Wireless Access Point & Client
Bridge. Please read the document carefully before setting up the ENH202. Any damage which
is caused by inappropriate use will not be covered under the warranty.
This document uses following symbols to indicate and highlight special messages.
Formats
Caution: This symbol represents a vital message and it is critical for the device
or settings.
Note: This symbol represents an important message for the settings.
Tip: This symbol represents an alternative choice that can save time or
resources.
The following equipment is required to setup the ENH202:
Before you start__________________________________________________
1. (1) Computer/Notebook and Internet access.
2. (2) Ethernet cables.
3. (1) EnGenius ENH202.
The equipment listed above is only for configuration of the ENH202, you will
need additional equipment to connect to the Internet and configuration will depend on your
current network infrastructure. Please refer to Chapter 2 for more information.