User's Manual
Table Of Contents
- 1 Product Overview
- 2 Installation
- This chapter describes how to install the ENH500.
- Select the optimal locations for the equipment using the following guidelines:
- 3 Wireless Network Modes
- 4 Configuring Your Computer for TCP/IP
- 5 Status
- 6 System
- 7 Wireless Configuration
- 8 LAN Setup
- 9 Router Settings
- 10 Management Settings
- 11 Network Configuration Examples
- Appendix A – Troubleshooting
- Appendix B – Specifications
- Appendix C – Glossary
- Appendix D – Statements of Conformity
11.2 Client Bridge Mode
Client Bridge Mode functions like a wireless dongle. It must connect to an Access Point/AP
Router to join the network.
Please refer to the last section to check the Access Point’s configuration.
Client Bridge
Step 1 Login to the web-based configuration interface with the default
IP: 192.168.1.1
Step 2 Select your country or region’s regulation.
Step 3 Select Operation Mode to Client Bridge from System
Properties.
Step 4 Use site survey to scan channels of the nearby area.
Step 5 Select the AP that you would like to associate with.
Step 6
Setup the authentication settings that match to the Access Point’s
settings.
Step 7 Select Apply to process all of the configurations.
The Client-Bridge’s IP settings must match the Access Point’s settings.
Access Point /
Wireless Router
Internet
ENH500
Client
192.168.1.2
192.168.1.1 192.168.1.10