User Manual

This device is intended only for OEM integrators under the following

conditions:

1) The antenna must be installed such that 20 cm is maintained between the

antenna and users, and

2) The transmitter module may not be co-located with any other transmitter or

antenna,

3) For all products market in US, OEM has to limit the operation channels in CH1

to CH11 for 2.4G band by supplied firmware programming tool. OEM shall not

supply any tool or info to the end-user regarding to Regulatory Domain

change.

As long as 3 conditions above are met, further transmitter test will not be required.

However, the OEM integrator is still responsible for testing their end-product for

any additional compliance requirements required with this module installed.

IMPORTANT NOTE: In the event that these conditions can not be met (for

example certain laptop configurations or co-location with another transmitter),

then the FCC authorization is no longer considered valid and the FCC ID can not

be used on the final product. In these circumstances, the OEM integrator will be

responsible for re-evaluating the end product (including the transmitter) and

obtaining a separate FCC authorization.