User's Manual

Advanced Operations

Handset Registration

1. If your handset is purchased as part of a system, it has been pre-

registered with the base station at the factory.

2. If the Handset ID reads “00”, that means it is a new handset or the ID

has been erased. You need to register the handset with the base

station. In certain situations, you may want to change a handset's ID.

For example, you want to change a particular handset from a user to an

administrator (ID 10 or 11), or vice versa. Or in some rare occasions,

you find another handset having the same Handset ID.

3. Registration:

a. Press -6 to enter the registration mode

b. Press and hold the base's Registration button for 2 seconds

until the L1, L2, L3, and L4 LED come on.

c. Press handset key , this completes the registration process.

The base station will assign a handset ID between 10 and 99. The

assigned ID will be displayed on the handset LCD, indicating

successful registration.

d. Repeat above steps for all additional handsets.

e. The first two handsets registered will be given ID 10 and 11, which

gives them administrator privileges.

Re : Base “00” is a primary base. All handsets must register to

Base “00”.

4. De-registration:

a. You can de-register a handset from a base. De-registration will reset

the Handset ID to 00, erase the system security code, and free up the

old ID for future registration.

b. After deregistration, the handset will not be able to use the base to

make or receive phone calls, nor can it use the intercom to reach

other handsets.

c. Press handset (Right softkey).

REG

d. Press the handset number key , this will enter the handset

registration menu.

e. Press and hold the base's button for 2 seconds until L1, L2, L3,

and L4 LED come on.

REG