IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.0 4.3.2 WPA-PSK Authentication & TKIP, AES Encryption WPA – PSK (Pre-shared Key) is used in a Pre Shared Key mode that does not require an authentication server. Access to the Internet and the rest of the wireless network services is allowed only if the pre-shared key of the computer matches that of the Access Point. This approach offers the simplicity of the WEP key, but uses stronger TKIP encryption.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter h h h h h h h h h h Version 1.0 Status: This indicates the state of the client. There are three options: o Associated: Indicates that the wireless client is connected to an Access Point (AP). The BSSID is shown in the form of 12 HEX digits, which is the MAC address of the AP. o Scanning: Indicates that the wireless client is searching for an AP in the area. o Disconnected: Indicates that there are no APs or clients in the area.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.0 4.5 Site Survey The Site Survey tab displays a list of Access Points and Stations in the area, and allows you to connect to a specific one. The following information is included in this tab, as the image depicts below. h h h h h h h h h h h SSID: Displays the SSID of the Access Point. The SSID is a unique name shared among all points in your wireless network. The SSID must be identical for all points in the network, and is case-sensitive.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.0 successfully without and after retry, received with CRC error, duplicate frames received, etc. 4.7 Advanced Configuration The Advanced tab is used to configure the wireless mode (802.11b-only, 802.11g-only, or 802.11b/g-mixed), B/G protection and country/channel setting.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter h h h Version 1.0 Wireless mode: Select 802.11 B/G/N mixed if the wireless network uses both 11b, 11g and 11n stations and APs. Tx Rate: The transmit rate should be set to auto, however you may manually select a transmit rate from the drop-down list. Click on the Apply button to save the changes.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.0 4.8 About The About tab displays information about the device, such as: the network driver version and date, configuration utility version and date, and the NIC (Network Interface Card) firmware version and date.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.0 Appendix A – Glossary 8 802.11 A family of specifications for wireless local area networks (WLANs) developed by a working group of the Institute of Electrical and Electronics Engineers (IEEE). A Access Control List ACL. This is a database of network devices that are allowed to access resources on the network. Access Point AP.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.0 Automatic Private IP Addressing APIPA.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.0 A program or user that requests data from a server Collision When do two devices on the same Ethernet network try and transmit data at the exact same time.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.0 DSSS: Modulation technique used by 802.11b wireless devices DMZ "Demilitarized Zone". A computer that logically sits in a "no-mans land" between the LAN and the WAN. The DMZ computer trades some of the protection of the router's security mechanisms for the convenience of being directly addressable from the Internet.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.0 Programming that is inserted into a hardware device that tells it how to function Fragmentation Breaking up data into smaller pieces to make it easier to store FTP File Transfer Protocol.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.0 Kbyte Kilobyte L L2TP Layer 2 Tunneling Protocol LAN Local Area Network Latency The amount of time that it takes a packet to get from the one point to another on a network. Also referred to as delay LED Light Emitting Diode Legacy Older devices or technology Local Area Network A group of computers in a building that usually access files from a server LPR/LPD "Line Printer Requestor"/"Line Printer Daemon".
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.0 NAT Network Address Translation allows many private IP addresses to connect to the Internet, or another network, through one IP address NetBEUI NetBIOS Extended User Interface is a Local Area Network communication protocol.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.0 PoE Power over Ethernet is the means of transmitting electricity over the unused pairs in a category 5 Ethernet cable POP3 Post Office Protocol 3 is used for receiving email Port A logical channel endpoint in a network. A computer might have only one physical channel (its Ethernet channel) but can have multiple ports (logical channels) each identified by a number.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.0 Wide Area Network WCN Windows Connect Now. A Microsoft method for configuring and bootstrapping wireless networking hardware (access points) and wireless clients, including PCs and other devices. WDS Wireless Distribution System. A system that enables the interconnection of access points wirelessly.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.0 Appendix B – Specifications Data Rates 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, 54, 72, 84, 150 and 300Mbps (300 Rx PHY rate; 150Mbps Tx PHY support) Standards / Compliance IEEE802.3, IEEE802.3u, IEEE802.11b, IEEE802.11g, 802.11n (2.0) Regulation Certifications FCC Part 15, ETSI 300/328/CE Operating Voltage 5 V ± 0.25V Status LEDs POWER / LINK Drivers Windows 2000/XP/Vista RF Information Frequency Band U.S.
IEEE802.11b/g/n Wireless LAN USB 2.0 Client Adapter Version 1.0 Appendix C – FCC Interference Statement Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Industry Canada statement: This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE: Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment.
Europe – EU Declaration of Conformity This device complies with the essential requirements of the R&TTE Directive 1999/5/EC.
Česky [Czech] Dansk [Danish] Deutsch [German] Eesti [Estonian] English Español [Spanish] Ελληνική [Greek] Français [French] Italiano [Italian] Latviski [Latvian] Lietuvių [Lithuanian] Nederlands [Dutch] Malti [Maltese] Magyar [Hungarian] Polski [Polish] Português [Portuguese] Slovensko [Slovenian] Slovensky [Slovak] [Jméno výrobce] tímto prohlašuje, že tento [typ zařízení] je ve shodě se základními požadavky a dalšími příslušnými ustanoveními směrnice 1999/5/ES.
Suomi [Finnish] Svenska [Swedish] [Valmistaja = manufacturer] vakuuttaa täten että [type of equipment = laitteen tyyppimerkintä] tyyppinen laite on direktiivin 1999/5/EY oleellisten vaatimusten ja sitä koskevien direktiivin muiden ehtojen mukainen. Härmed intygar [företag] att denna [utrustningstyp] står I överensstämmelse med de väsentliga egenskapskrav och övriga relevanta bestämmelser som framgår av direktiv 1999/5/EG.