Technical data

--- 37 ---
11. INSPECTION AND CONFIRMATION AFTER REASSEMBLY
Check that Safety Plunger (B) [61] and Trigger Plunger [68] move smoothly.
Check that there is no air leakage from each part.
While driving nails with an air pressure of 4.5 kgf/cm
2
(63 psi), check that there is no idle driving and bending
of nails.
Note: Before conducting the driving test, turn Adjuster [39] to the deepest position.
Recheck the tightening torque of each screw.
Check that Pushing Lever [54] slides smoothly.
Check that the machine will not operate only by pulling the Trigger [62]. Also check that the machine will not
operate only by depressing the Pushing Lever [54].
Push Sub Nail Stopper [92] and Feeder Set [35] with fingers to check that they smoothly return to position.
Check that the Feed Piston [70] operates properly at 5 kgf/cm
2
(70 psi. 4.9 bar) (Open the Nail Guide [95] and
perform idle driving.).
Check that the Trigger [62] moves smoothly.
Check that the Adjuster [39] turns smoothly.