Operation Manual

EN-4
EN
Coffeemaker
SCE 3000BK
05/2015Copyright © 2015, Fast ČR, a.s.
IMPORTANT SAFETY INSTRUCTIONS
READ CAREFULLY AND STORE FOR FUTURE USE.
Before connecting the appliance to a power socket check that the technical specifications on the
appliance's rating label match the electrical voltage in the socket.
Connect the appliance only to a properly grounded socket.
Attention:
This appliance is not designed to be controlled using a programmed device, external timer
switch or remote control.
This appliance is designed for domestic use and similar locations such as:
staff kitchens in stores, offices and other workplaces;
hotel or motel rooms and other living areas;
bed and breakfast establishments.
Only use the appliance to brew drip coffee.
Do not place the appliance on window sills or on unstable surfaces.
The appliance must always be located on a stable, even and dry surface.
Never use the appliance in the near vicinity of a bath, shower or swimming pool.
Only fill the water tank with cold drinking water. Do not fill it with any other liquid or place any
objects inside it. When filling the water tank, the appliance must be turned off. During repeat use,
fill the water tank before the appliance cools down.
Only use the appliance with the glass kettle that came with it. Do not place the glass kettle on other
sources of heat or use it for heating in a microwave oven.
Do not use the appliance with a glass kettle that has a loose or damaged handle or cracked wall. If
the kettle exhibits any signs of damage, it must be replaced with a new one.
Do not place any items on the hotplate and lid of the appliance.
Before turning on the appliance, check that the water tank is filled with water and that the lid of
the water tank/steam chamber is properly closed.
During operation, leave at least 20 cm of free space above the appliance.
Warning:
During the coffee brewing process, do not move the lid or the aroma regulator and do not touch
the heated surface of the hotplate or glass kettle. This could cause burns. Use the handle for
lifting and carrying.
Pay extra attention when handling the kettle filled with hot coffee to prevent scalding.
Do not place a heated kettle on a wet or cold surface or submerge it in water. Do not leave an
empty kettle sitting on a heated hotplate. This could damage it.
Allow the appliance to cool down for at least 10 minutes before using it again.
Always disconnect the appliance from the power socket before moving or cleaning it.
Allow the appliance to fully cool down before moving or cleaning it. Do not move the appliance
with a full water tank or with the kettle located on the hotplate.
Do not clean the appliance (excluding the glass kettle, permanent filter and filter holder) under
running water and do not submerge it under water or any other liquid.
Do not place the appliance on or near an electric or gas stove or other sources of heat.
To prevent the appliance from falling, locate the power cord so that it does not hang over the edge
of a table.
Ensure that the power cord does not come into contact with water or moisture or a heated surface.
Do not disconnect the appliance from the power socket by pulling on the power cord. This could
damage the power cord or the power socket. Disconnect the cord from the power socket by gently
pulling the plug of the power cord.
If the power cord is damaged, have it replaced at a professional service centre. It is forbidden to use
the appliance if it has a damaged power cord or plug.
To avoid the danger of injury by electrical shock, do not repair the appliance yourself or make any
adjustments to it. Have all repairs or adjustments of the appliance performed at an authorised
service centre. Tampering with the appliance during the warranty period may void the warranty.