Operation Manual

EN-8

Electric Coffee Grinder

SCG 2050RD / SCG 2051BK / SCG 2052WH

11/2016

BEFORE FIRST USE

1. Remove the coffee grinder from the packing material.

2. Turn the lid A1 anticlockwise to release it, then take it off. Wash it under warm running water using

kitchen detergent. Then rinse it with clean water and thoroughly wipe dry.

3. Wipe the hopper A2 and the grinding blade A3 with a clean lightly dampened wiping cloth and

then wipe it until it is thoroughly dry.

Attention:

When cleaning the grinding blade A3, be very careful not to injure yourself on the sharp edge.

USING THE COFFEE GRINDER

1. Wind the power cord out of the storage area A7.

2. Turn the lid A1 anticlockwise to release it, then take it off. Pour coffee beans into the hopper A2. The

hopper A2 has a maximum capacity of 60 g of coffee beans. Do not ﬁll the hopper A2 past the edge.

Tip:

You may also use the coffee grinder for grinding nuts, herbs, poppy seeds and certain types of

spices. Shells must be removed from nuts before grinding.

Attention:

Do not use the coffee grinder to grind excessively hard foodstuffs such as nutmeg, etc.

3. Place the lid A1 on to the hopper A2 and turn it clockwise until the symbols marked on the lid

A1 and the coffee grinder base unit A4 line up. This will lock the lid A1 in place. When locked in

place, the lid A1 cannot be lifted off. The coffee grinder is equipped with a safety mechanism that

prevents it from being started when the lid A1 is not properly attached.

4. Connect the coffee grinder to a power socket and press the pulse button A5 to start it. The coffee

grinder will continue to run while the button A5 is pressed. The coarseness of the ground coffee

depends on the grinding time. The longer you grind it, the ﬁner it will be.

Attention:

The maximum continuous operating time is 30 seconds. After 30 seconds of continuous

operation, allow the coffee grinder to rest for 2 minutes.

Tip:

Always prepare your coffee beverage from freshly ground coffee. Coffee that is ground in

advance loses its ﬂavour and aroma.

5. To stop the coffee grinder, release the pulse button A5. Disconnect the coffee grinder from the power

socket. Make sure that the grinding blade A3 has stopped rotating. Turn the lid A1 anticlockwise

to release it, then take it off. Tip the ground coffee into a suitable container.

6. Clean out the coffee grinder after each use according to the instructions in chapter Cleaning and

maintenance.