Use and Care Manual

Food Mixer
STM 3620WH, STM 3621GR, STM 3622BL, STM 3623OR, STM 3624RD
STM 3625VT, STM 3626YL, STM 3627TQ, STM 3628RS
EN
EN-7
2015 07/2015
2.4 If you will not be immediately placing ingredients into the mixing bowl A4, press the PUSH button
A9 and tilt the arm A8 to the horizontal position. When the arm A8 is tilted to the horizontal
position, the PUSH button A9 will slide out accompanied by an audible click.
3. Removing the attachment and mixing bowl
3.1 Release the arm A8 by pressing the PUSH button A9 and tilt it upwards. The arm A8 is locked in
the open position when the PUSH button A9 slides out together with an audible click.
3.2 Hold the attachment and gently push it towards the mixing head A7. Then rotate it clockwise until
it is released from the motor shaft and take it off. Turn the mixing bowl A4 anticlockwise and take
it off the base unit A5. Move the arm A8 back to the horizontal position.
OPERATING THE APPLIANCE
1. Unwind the necessary length of power cord from the compartment Aqs.
2. Release the arm A8 by pressing the PUSH button A9 and tilt it out.
3. Into the bowl A4 that is seated in the base unit A5, place the ingredients.
Attention:
The maximum weight of the ingredients that can be processed in a single batch is 1.6 kg. When
preparing bread dough, do not process more than 600 g of flour at once. When preparing dough
for sweet pastries (fruit cakes, etc.) it is possible to process no more than 450 g of flour at once.
The maximum number of egg whites that can be whisked at once is 8.
4. Press the PUSH button A9 and tilt the arm A8 together with the attached attachment to the
horizontal position.
5. Make sure that the food mixer is correctly assembled and that the speed control knob A0 is set
to position 0 (stand-by mode). Connect the power cord to the el. power socket. Connection to
a working power socket is indicated by the speed control knob A0 being lit.
6. Use the speed control knob A0 to set the required speed level from 1 to 6. First, set a lower speed
to prevent ingredients from being sprayed around. As soon as they are mixed together, increase the
speed to the required level. The speed can be adjusted at any time as required.
The pulse mode is used for increasing the speed to maximum for a short time. To activate the
pulse mode, turn the speed control knob A0 to the PULSE position and to ensure continuous
operation hold it down in this position. As soon as you release the speed control knob A0, it will
automatically return to position 0 (off).
Attention:
If it is necessary to wipe ingredients off the inside of the mixing bowl A4 and the attachment,
first turn off the food mixer by setting the speed control knob A0 to position 0 (stand-by mode)
and then disconnect it from the power socket. Then wipe away the ingredients using a plastic
spatula.
The maximum operating time is 6 minutes. Do not leave the appliance in continuous operation
for longer than indicated above. This is especially true under a heavy load (e.g. when processing
heave, thick doughs). If the appliance is in operation under heavy load, allow it to cool down for
at least 10 minutes before turning it on again. At lower loads, a cooling time of 3 to 5 minutes
is usually sufficient.
7. After you have finished using the appliance, set the speed control knob A0 to position 0 (stand-by
mode) and disconnect the power cord from the power socket.
8. Disassemble the food mixer according to the instructions included in chapter Assembling and
disassembling the appliance. Use a soft plastic spatula to remove mixes from the mixing bowl A4
and the attachment.