Instruction manual
EN - 10
Troubleshooting
If a fault occurs, fi rst check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following hints, consult your dealer or service center.
Note: Do not open the unit as there is a risk of electric shock. Under no circumstances should you
try to repair the set yourself; as this will invalidate the guarantee.
No power
• Ensure that the power cord connect securely.
• Ensure that there is power at the AC Mains.
• Ensure that the batteries are inserted correctly.
No sound or poor sound
• Adjust the volume.
No response from the unit
• Disconnect and reconnect the AC power cord, then turn on the unit again.
• Electrostatic discharge, re-connect the AC power cord after a few seconds.
CD does not play
• The disc is dirty. Clean the CD.
• The disc is placed upside down. Remove and place the CD right side up.
• Use a fi nalized CD or correct format disc.
The CD skips tracks
• Ensure that the CD is not damaged or dirty.
• Ensure that program mode is deactivated.
Poor radio reception
• Electrical interference in your home can cause poor reception. Move the unit away from them
(especially those with motors and transformers).
• Fully extend the telescopic antenna.
The unit does not function properly while using batteries
• Batteries are dead. Replace the new batteries.
• The polarities of the batteries are incorrectly positioned.
• Reinsert the batteries ensuring the polarities (+/-) match the unit’s indicated polarities (+/-).
File from MP3 disc does not play
• Check the fi le format. This product only support MP3 format.
Remarks:
• If the unit is not used for 30 minutes or more, it will automatically enter STANDBY mode.
Press the PROGRAM/RESTART button to resume use.
• If any anomaly occurs, switch the FUNCTION Selector to OFF position, and then switch it
back to CD/MP3 or FM ST. position again.