Instruction manual

EN - 1
Safety Precautions
• Read all instructions carefully before using the unit and keep them for further reference.
• Retain the manual. If you pass the unit onto a third party makes sure to include this manual.
• Check that the voltage marked on the rating label matches your mains voltage.
Damage
• Please inspect the unit for damage after unpacking.
• Do not continued to operate the unit if you are in any doubt about it working normally or if it is
damaged in any way - switch off, withdraw the mains plug and consult your dealer.
Location of Unit
• The unit must be placed on the fl at stable surface and should not be subjected to vibrations.
• Do not place the unit on sloped or unstable surfaces as the unit may fall off ir tip over.
• The mains socket must be located near the unit and should be easily accessible.
Temperature
• Avoid extreme degrees of temperature, either hot or cold. Place the unit well away from heat
sources such as radiators or gas/electric fi res.
• Avoid exposure to direct sunlight and other sources of heat.
Naked Flames
• Never place any type of candle or naked fl ame on the top of or near the unit.
Moisture
• To reduce the risk of fi re, electric shock or product damage, do not expose this unit to rain,
moisture, dripping or splashing. No objects fi lled with liquids, such as vases, should be placed on
the unit.
• If you spill any liquid into the unit, it can cause serious damage. Switch it off at the mains
immediately. Withdraw the mains plug and consult your dealer.
Ventilation
• To prevent the risk of electric shock or fi re hazard due to overheating, ensure that curtains and
other materials do not obstruct the ventilation vents.
• Do not install or place this unit in a bookcase, built-in cabinet or in another confi ned space.
Ensure the unit is well ventilated.
Safety
• Always disconnect the unit from the mains supply before connecting/disconnecting other devices
or moving the unit.
• Unplug the unit from the mains socket during a lightning storm.
Mains Cable
• Make sure the unit or unit stand is not resting on top of the mains cable, as the weight of the unit
may damage the mains cable and create a safety hazard.
• If the mains cable is damaged it must be replaced by the manufacturer, its service agent, or
similarly qualifi ed persons in order to avoid a hazard.