User`s manual

EN - 2
LED DISPLAY
POWER CONNECTION
Plug the AC power cord to a household outlet AC source. This unit is equipped with a battery back up system,
it requires a 3V CR2032 flat lithium battery (not included). Insert the battery in the battery compartment,
making certain that the positive and negative (+ and -) battery terminals are attached to the corresponding
terminals on the plate in the battery compartment. If an AC power failure occurs, the clock automatically
switches to the battery power supply, the clock and timer mem
ory continue running. When the AC power
resumes, the clock switches back to AC again.
GETTING STARTED
Press the RESET button (16) locates on the back of unit after AC plug in.
- The unit will display full segment for 2 seconds, then it will enter the normal mode.
1. TIME AND CALENDAR MANUAL SETTING
A. Setting Time and Calendar – Press Time set button (5) in normal mode and keep depress over 2 seconds
to enter time set mode, after enter the setting mode, press Time set button (5) to change the mode
cycle
as follows :
Normal → Year → Month → Day → 12/24 H → Real time Hour → Real time Min → Normal
Action (during data adjustment):
- Press << / Tune - button (6) to adjust data backward.
- Press >> / Tune + button (7) to adjust data forward.
- Keep depress << or >> button for 2 seconds to enable auto forward.
B. Setting Alarm 1 and Alarm 2 – Press alarm set button (2/3) during normal mode and keep depress over
2 seconds to enter alarm set mode, after enter the setting mode, press alarm set button (2/3) to change
the
mode cycle as follows :
Normal → AL 1 Hour → AL 1 Min → AL 1 weekday Alarm → AL 1 wake beep → AL 1 wake radio → AL 1
wake radio volume → Normal
Normal → AL 2 Hour → AL 2 Min → AL 2 weekday Alarm → AL 2 wake beep → AL 2 wake radio → AL 2
wake radio volume → Normal