Use and Care Manual

Stand mixer
STM 40WH-NAB1 / STM 41GR-NAB1 / STM 42BL-NAB1 / STM 43OR-NAB1 / STM 44RD-NAB1
STM 45VT-NAB1 / STM 46YL-NAB1 / STM 47GG-NAB1 / STM 48RS-NAB1 / STM 4XXX-NAB1
EN
EN-13
2015 08/2015
tube that is then cut into smaller pieces. The kebab is a traditional meal from the Middle East made
predominantly from ground meat and whole grain wheat.
Attention:
Do not use fi ngers or other utensils to push the ground meat mixture through the feed tube B3.
Always use the pusher B1 designed for this purpose.
3. To turn off the appliance, set the speed control knob Aqa to the OFF position.
4. Clean out the individual parts of the attachment after each use according to the instructions in
chapter Cleaning and maintenance.
GRATING AND SLICING
ASSEMBLING AND DISASSEMBLING THE GRATING AND SLICING ATTACHMENT
1. The attachment is assembled by inserting one of the graters C4, C5 or C6 into the chamber C3.
2. Check that the appliance is turned off and disconnected from the el. power socket. The arm A8
must be tilted down to a horizontal position and the attachment A1, A2 or A3 must be removed.
Remove the cover A7 from the multi-function head and push the assembled attachment at an
angle of 45° against the attachment hub that is located on the front part of the multi-function
head and secure it in place by turning it anticlockwise (fi g. D). The attachment is secured in the
vertical position when the push button A6 slides out together with an audible click.
3. Now the attachment is ready for operation.
4. To disassemble, press the button A6 (see fi g. E) and remove the attachment by turning it clockwise.
When disassembling the attachment into its individual parts, proceed in the reverse sequence.
USING THE GRATING AND SLICING ATTACHMENT
1. The attachment is designed for grating or slicing fruit and vegetables (e.g. potatoes, beetroot,
cabbage, carrot, cucumber, apples, etc.) and for making breadcrumbs.
2. Prepare the ingredients and cut them into pieces that will pass through the feed tube C2. Remove
kernels and stones from the fruit and vegetables.
Attention:
Do not process frozen food. Under no circumstances should you attempt to process hard stones
that are found for example in mango or avocado.
3. Make sure that the appliance is correctly assembled and that the speed control knob Aqa is set to
the OFF position. Insert the power plug into an electrical power socket.
4. Place the stainless steel bowl A4 or another suitable container under the attachment. Use the
speed control knob Aqa to set the desired speed. We recommend to initially set the lowest speed
and then increase it as required.
5. Gradually add the ingredients into the feed tube C2 and push through using the pusher C1.
Attention:
Do not use fi ngers or other utensils to push ingredients through the feed tube C2. Always use
the pusher C1 designed for this purpose.
6. To turn off the appliance, set the speed control knob Aqa to the OFF position.
7. Clean out the individual parts of the attachment after each use according to the instructions in
chapter Cleaning and maintenance.