User manual

MRD 3187B User Manual
Page 149
Note: In Auto mode, the program number should be entered as the number of the
program in the TS.
Note: In Priority mode, the service number is entered and the audio entries should be
entered as the number they are indexed by, in the TS.
Note: In No PSI mode, all of the entries should be entered as PIDs with their
corresponding data type.
5.3.2.2 Audio Status and Downmix Settings
The audio downmix settings have three different configuration settings. These three are:
transmission, monitor, and user. To configure the audio downmix setting, use the
following steps:
1. Click on the or tab of the corresponding RDS that needs to be
configured.
Note: In a Configuration 1 MRD 3187B, there will only be a tab.
2. Under the “Services” heading,
click on the button next to
the corresponding audio to
configure.
3. A new window should pop up in
the middle of the screen. Use
the drop down menu at the top
to choose the appropriate audio
downmix configuration.
4. Depending on the chosen
configuration, use the remaining drop down
menus to finish the setup.
5. Click the button to save the
settings.
Note: Use the previous steps to setup the other
audio dowmixes as well.
5.3.2.3 Source ID
To setup the Source ID, use the following
steps:
1. Click on the or tab of the
corresponding RDS that needs to be
configured.