User manual

MRD 3187B User Manual
Page 188
Video Output (2 SDI, 1 RGBHV/YPbPr/Composite) – Option 8712
SDI outputs 1 and 2 can be set to either HD-SDI or SD-SDI independently.
General –
RoHS Compliant: Yes
Connector: (2) Female BNC
Impedance: 75ohms +/- 10%
Output Connectors: 2 –SDI, 1 – RGBHV/YPbPr/Composite
(Composite/YPbPr output with breakout cable only)
Genlock -
SDI: Line and Pixel Adjustment
Composite: Line, Pixel, Color Phase Adjustment
SDI (Serial Digital Interface) Video Out –
HD-SDI Standard: SMPTE 292M
SMPTE 274M (1080I, 29.97Hz)
SMPTE 296M (720P, 59.94Hz)
SD-SDI Standard: ITU-BT.601/SMPTE 259M
Data Bit Rate: SD-SDI = 270Mbps
HD-SDI = 1.485Gbps
Display Modes: Letterbox, cropped, anamorphic
Embedded Audio Format: SD-SDI = SMPTE272M
HD-SDI = SMPTE 299M
Sample Rates Supported: 48KHz
Sample Rate Out: 48KHz
Output Squelch: Enable, (Output muted if no input detected)
Disable, selectable
Number of Embedded Audio Channel Pairs: 8 (4 complete audio groups)
Audio Types Supported: AC3, MPEG2 layer 1 and 2, or PCM
DolbyE (With 8707A)
Embedded Audio Control: Selectable – “type”/disable
(Each pair independently controlled)
Audio Type Standard: Compressed (IEC 60958)
Uncompressed (IEC 61937)
Closed Captions: Embedded - EIA-708B or EIA-608B
Line21 – Enable/Disable (selectable) SDI and
Composite controlled simultaneously.
Analog Video –
Video Format Standards: SMPTE274M (1080i)
SMPTE 296M (720p)
SMPTE 253M (480p, 480i)
(Reference: EIA 770.2 and 770.3)
Number of Analog Outputs: 1 (shared: RGBHV or YPbPr/Composite via
breakout cable)
Connector: High Density 15-pin D-sub, female
Impedance: 75 ohms, +/-10%, 1kohm for syncs
Return Loss: >20dB, 30KHz – 30MHz
Frequency Response: Y = 30KHz - 30MHz, +/-0.2dB ripple
PbPr = 30KHz – 15MHz, +/-0.2dB ripple
H/V Sync: 4Vpp into 1 M ohm, positive polarity
Specifications are subject to change without notice.