USER MANUAL KY-26 KYD-26 KY-32 KYD-32 KY-44 KYD-44 PORTABLE AIR-CONDITIONER Thank you for selecting super quality air conditioner. Please be sure to read this manual carefully before using it. Any question, please contact the professional service for help.
CONTENTS CONTENTS ................................................................................................................... 1 IMPORTANT SAFEGUARDS ................................................................................. 2 FEATURES AND PARTS LIST .............................................................................. 4 PANEL CONTROL...................................................................................................... 5 REMOTE CONTROL .................................
IMPORTANT SAFEGUARDS Important Safeguards. •Read all instructions. •Disconnect the power plug before dismantling, assembling or before cleaning. •Avoid touching mobile parts of the appliance. •Never insert fingers, pencils or any other objects though the guards whenever the power plug is connected, especially while running.
Energy Saving Tips. • Do not cover or restrict the airflow from the Outlet or Inlet grills. • The minimum distance from furniture and wall should be 50cm. • Keep blinds and /or draperies, on any windows, closed during the sunniest part of the day. • Keep the filters clean. Under normal conditions, the filters should be cleaned approximately every 30 days. Since the filters remove airborne particles, more frequent cleaning maybe necessary, depending on the indoor air quality.
FEATURES AND PARTS LIST Features: ·No installation is required. ·Easily moved . The handle makes moving more convenient. ·Streamline colorful screen display . ·LED colorful screen display. ·Water-cooled mode is most energy saving and environment protect. ·Low noise and strong wind . ·Unique economic function. ·Auto swing makes wind blow from left to right automatically. ·Three-minute restart delay to protect compressor. Parts list: 1. control panel 2. horizontal louver 3. vertical louver 4.
PANEL CONTROL CAUTIONS: If the unit is turned off in cool /dry/ heat mode and restarted immediately , then it will wait at least 3minutes before running again. 1. Buttons Timer: press this button to set the timer Swing: press this button to make the vertical louver swing automatically. Press once again, the swing will stop. Speed: press this button for 5 seconds to select high, middle or low fan Speed. Up/down: press up or down button to set temperature or adjust the time in Timer mode.
REMOTE CONTROL Power Press this button to turn/off the unit. Timer Press this button to set the timer. Swing Press this button to make the vertical louver swing automatically Vary from Celsius degree to Fahrenheit degree. Cool Press this button to choose Cool mode. Heat Press this button to choose Heat mode. Dry Press this button to choose Dry mode. Fan Press this button to choose Fan mode. Up Down Press Up or Down button to set temperature or adjust the time in Timer mode.
OPERATION METHODS Timer set 1.Set timer-off Press the Timer button when the unit is on. The LED will flash_ _five Times. During this period press Up or Down button to adjust set time from 0.5h to 24h. It will vary 0.5h each time in 3h and 1h each time hereafter. The set time will flash 5 times after adjusting. When it will display temperature again. Once the set time end, the unit will turn off automatically. 2. Change the set time When Timer is on, you can check remnant time by pressing Timer button.
INSTALLATION 1.Selection of Installation Place Install the unit on a flat and dry place. Leave at least 50cm space around the unit(when the hose is not connected). (Fig.5) 2.AIR Exhaust Duct Mounting Method 1) Fix the square end of the exhaust dust to the exhaust terminal of the unit. 2) Put the other end (discharge) to the nearest window. Leave at least 50cm place around it. NOTE: The length of the air exhaust duct is between 600cm to 1700cm or 1800cm (adapters included).
4.Mounting illustrations 1.mounting in the wall 2.correct bending 3.
WATER DRAINGE METHODS This product has a self-evaporative system. The condensing water will recycle to cool the condenser. This water-cooled mode can not only improve cooling efficiency and decrease noise, but also save energy for you. * When in cooling mode, the water from the evaporator will flow into a inside pan. When the water reaches the low level, the water pump will work until the water is under the low level.
MAINTENANCE Cleaning Turn off the unit and pull the plug out of the socket before any cleaning. 1.Clean the surface Clean the surface of the unit with a duster or a half-wet soft cloth. Do not use chemical solvent like benzene, alcohol, gasoline and etc, Or the surface may be damaged or even deformed. 2. Clean the air filter If the air filter is blocked with a lot of dust, the efficiency will reduce. You’d better clean the filter every two weeks. 1) Pull out the air filter as Fig.14.
TROUBLE SHOOTING Before contacting professional service, please firstly check it yourself referring to the followings. Trouble Check Solution Is power fail? Is plug out? It is normal. Insert the plug into the The unit doesn’t socket steadily. operate at all. Is power fuse or switch off? Change the fuse or switch on. Is the set time suitable? Change the set time. Is water full alarm on? Pour the water. Is air inlet or outlet blocked? Clear off the blocks. Is there any other heat Move the heat source.
INSTALLATION ACCESSORIES Description: Flexible exhaust hose with adapters ……3/set Stretch from 7000BTU/8000BTU/9000BTU:14” (36cm) up to 59” (150cm) 12000BTU/14000BTU/15000BTU:15” (38cm) up to 59” (150cm) Window exhaust adapter (flat mouth)……1pc Adjustable window slider kit ………………2/set From 35 3/8” (90cm) up to 51 1/8” (130cm) Screw (the length is 3/8”)………………………1pc Drain pipe ………………………………………1pc Plug (square)……………………………………1pc Water cup ………………………………………1pc 13
APPENDIX 1.Fuse Parameter Type: FSD Voltage: 250V Current: 3.15A 2.Wiring Diagram Fig.16 Disposal: Do not dispose this product as unsorted municipal waste. Collection of such waste separately for special treatment is necessary.
