User's Guide Part 1

6 Sendo Z100 User Guide
1
The Basics
Antenna
• The Z100 has an internal antenna which is
located on the rear of the phone, above the
battery compartment.
z Warning: Contact with the antenna affects call
quality and may cause the phone to operate at
a higher power level than otherwise needed.
For best results avoid covering the antenna area
with your hand.
External Antenna port
• This is located on the back of the phone. Use this
to connect to a different antenna, for example, a
car kit could plug into this to use with an antenna
mounted on the outside of your car.
Microphone
• Speak into the microphone during a call or to
record a voice memo or voice tag. You don’t
need to speak directly into the phone when
you’re using speakerphone mode.
Headset Connector
• Use to connect the stereo headset. You can use
the headset to make and receive voice calls or to
listen to music and other audio.
IrDA port
• Align the IrDA (Infrared) port with the IrDA port
on another device to exchange information
between your phone and another device.
Accessory connector
• Use this connector to attach included, or optional
accessories such as the USB or RS232 serial
cable, or a digital camera.
Charger connector, or in car charger
Plug the approved AC (Mains) charger in here.
Numeric Keypad
• Used to enter numbers and characters.
Asterisk key (*)
• Pressing and holding the asterisk key * switches
between text and numeric input modes. In
multitap text or predictive text modes, a short
press switches between caps, caps lock and
lowercase entry.
Hash key (#)
• Press and hold the Hash key# to display a list of
symbols when you are in input mode.
z100.book Page 6 Wednesday, September 18, 2002 4:03 PM