User's Guide Part 2

65 Sendo Z100 User Guide
6
Synchronizing Informa-
Microsoft® ActiveSync® 3.6 System
Requirements
Minimum Desktop Computer Requirements
• Microsoft® Windows® XP, Microsoft® Windows®
2000, Microsoft® Windows® Millennium Edition,
Microsoft® Windows NT® Workstation 4.0 with
SP 6 or later, or Microsoft® Windows 98
• Microsoft Outlook® 98 or later required for
synchronization to the desktop or portable
computer of e-mail, calendar, contacts, tasks,
and notes.
• Microsoft Internet Explorer 4.01 SP1 or later
• Hard disk drive with 12 to 65 MB of available
hard disk space (actual requirements will vary
based on selection of features and user’s current
system configuration)
• Available 9 or 25-pin communications port
(adaptor required for 25-pin communications
port), infrared port, or USB port (available for
Windows 98, Windows Millennium Edition,
Windows 2000, Windows® XP only)
• One CD-ROM drive
• VGA graphics card or compatible video graphics
adapter at 256 colour or higher
• Keyboard
• Microsoft Mouse or compatible input device
z Note: If you’re using NT4.0, ActiveSync only
works with Service Pack 6 or greater. Contact
your local Microsoft country office or check the
local Microsoft website for upgrade details.
Options for Windows XP, Windows 2000,
Windows Millennium Edition, Windows NT
Workstation 4.0, or Windows 98
• Audio card/speakers for sound
• Microsoft Office 97, Microsoft Office 2000, or
Microsoft Office XP
• Modem for remote synchronization
• Ethernet LAN connection for remote
synchronization
Getting Started with ActiveSync®
ActiveSync®is already installed on your phone, but
before you can begin synchronizing with your
desktop PC you may need to install ActiveSync® on
your desktop. You can install ActiveSync®, from the
Z100 Companion CD.
When ActiveSync® is installed you must connect
your phone to your desktop PC.
X To connect the Z100 to your desktop computer using
a cable
1. Plug the data cable into the Accessory connector
on the bottom of your Z100.
2. Plug the other end of the cable into the USB port
of your desktop computer.
X To connect the Z100 to your desktop computer using
a cradle
1. Plug the cable into the USB port on your desktop
computer.
z100.book Page 65 Wednesday, September 18, 2002 4:03 PM