SENDUM WIRELESS, CORP. Table of Contents 1 2 Purpose ..................................................................................................... 3 Introduction .............................................................................................. 3 2.1 2.2 3 What is a DS500.................................................................................................. 3 How does a DS500 work.....................................................................................
SENDUM WIRELESS, CORP. 1 Purpose The purpose of this guide is to describe the basic features of the DS500. 2 Introduction 2.1 What is a DS500 Ø The DS500 is a wireless tracking device which operates on the CDMA network using assisted GPS for location. Ø It is used for tracking valuable assets (such as tools, machinery, etc) in construction sites. 2.2 How does a DS500 work Ø It establishes a data connection through either the cellular or the PCS band similar to a mobile phone.
SENDUM WIRELESS, CORP. 3.2 Installing the Battery The battery is inaccessible by users 3.3 Removing the Battery The battery is inaccessible by users 3.4 Charging the Battery New batteries are shipped partially charged. Before you can use your device, install and charge the battery as described below. Some batteries perform best after several full charge/discharge cycles. 3.4.1 Charging using the DS500 Device Simply attached the Sendum charger into the device and plug the AC adapter to the AC outlet.
SENDUM WIRELESS, CORP. Ø Select the com port that the device is communicating, then press “Connect”. The ESN will be shown. Ø If the device is already provisioned, the “Read” button is used to check. Ø Now all provisioning parameters can be entered into the appropriate boxes. Ø Press “Write” to load into the device. 5 DS500 Command Set The DS500 supports the following commands.
SENDUM WIRELESS, CORP. //BREW:0x12345678:PSW2,COMMAND,STATUS Causes the device to send a status report. //BREW:0x12345678:PSW2,COMMAND,LOCATE Causes the device to locate itself and send a location report. //BREW:0x12345678:PSW2,REPORT,STATUS, Causes the device to send a status report every seconds. //BREW:0x12345678:PSW2,REPORT,LOCATION, Causes the device to send a location report every seconds.
SENDUM WIRELESS, CORP. 5 6 7 8 9 wait 75 seconds before locating again wait 90 seconds before locating again wait 105 seconds before locating again wait 120 seconds before locating again wait 135 seconds before locating again To stop Tracking your VT100 in this mode, send it the following SMS message: PSW1,LOCATE,0 6.
SENDUM WIRELESS, CORP. 8 Troubleshooting Email your requests to supports@sendum.
SENDUM WIRELESS, CORP. 9 HUMAN EXPOSURE COMPLIANCE STATEMENT The following statement addressing human exposure to the RF energy emitted by the Modem is included in the “User's Manual." Pursuant to 47 CFR § 24.52 of the FCC Rules and Regulations, personal communications services (PCS) equipment is subject to the radio frequency radiation exposure requirements specified in § 1.1307(b), § 2.1091 and § 2.1093, as appropriate.
SENDUM WIRELESS, CORP. Ø Never expose your DS500 to high temperatures, such as those found near a heater. This can cause heat damage to the plastic components, the electronic components, and the backup battery. Ø Never drop your DS500 or expose it to violent impact or shock. This can cause mechanical damage. Ø Never use harsh chemicals, cleaning solvents, or strong detergents to clean your DS500. Ø Never attempt to dispose of your DS500 by throwing it into a fire.