User Manual
CLEANING & STORAGE
After removing the tracking unit from the client’s ankle, clean the
unit by wiping the case with a soft cloth. You can use Lysol as a
disinfectant if needed. Do not use Pinesol or any cleaning products
containing pine oil, as these solvents may damage the plastic body.
Store the tracking unit in its original shipping case. As an alternative,
you can clean the tracking unit in a standard dishwasher.
16 • BI ExacuTrack One Quick Installation Guide • 8-90-00130-0, Revision A
FCC NOTICES
1. Changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
2 This device complies with part 15 of the FCC Rules. Operation is subject to the condition that
this device does not cause harmful interference.
3. THIS DEVICE MEETS THE GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO RADIOWAVES.
This ankle device is a radio transmitter and receiver. It is designed and manufactured
not to exceed the emission limits for exposure to radio-frequency (RF) energy.These
limits are part of comprehensive guidelines and establish permitted levels of RF
energy for the general population.The guidelines are based on standards that were
developed by independent scientic organizations through periodic and thorough
evaluation of scientic studies. These guidelines include a substantial safety margin
designed to ensure the safety of all persons, regardless of age and health.
The exposure standard for this ankle bracelet employs a unit of measurement known as the
Specic Absorption Rate, or SAR.The SAR limit set by public authorities such as the
Federal Communications Commission of the US Government (FCC), or by Industry
Canada, is 4 W/kg averaged over 10 gram of body tissue. Tests for SAR are
conducted using standard operating positions with the transmitting at its
highest certied power level in all tested frequency bands.
Although the SAR is determined at the highest certied power level, the actual SAR
level of the ankle bracelet while operating can be well below the maximum value.This is
because the ankle bracelet is designed to operate at multiple power levels so as to use
only the power required to reach the network. In general, the closer you are to a
wireless base station antenna, the lower the power output of the ankle .
4. IC Manual requirements
This Class B * digital apparatus complies with Canadian ICES-003.