User Manual

Step 1
While the tracking unit is
still on the client’s ankle,
insert a screwdriver into
the notched grooves on
the locking pins. Turn
the screwdriver counter-
clockwise until the hinge
assembly is released. You
must complete this step for
both locking pins on each
side of the hinge assembly.
Discard the locking pins.
Step 2
Pull firmly on the fixed
strap to release the
fiber-optic connector
from the hinge post.
Step 3
Remove the hinge assembly
from the adjustable strap.
Clean the hinge assembly
with Lysol or similar
product, and store the
assembly for reuse.
To Remove the Tracking Unit: Steps 1-6 >
WARNING! Do NOT cut the strap to remove the tracking unit from the
client’s ankle.
14•BIExacuTrackOneQuickInstallationGuide•8-90-00130-0,RevisionA
INTRODUCTION
The ExacuTrack One tracking unit is a GPS device secured around the
client’s ankle. This device includes the following features:
 • GPSReceiver
 • AFLTLocationTechnology
 • AssistedGPSTechnology
 • RFReceiver
Use this guide to properly install the tracking unit on your client’s ankle.
Fordetailedinformationaboutthisproduct,seetheBI ExacuTrack One
Officer’s Reference Guide.
INSTALLATION
The installation process for the ExacuTrack One tracking unit involves
three separate steps:
 • Assemblingthetrackingunit
 • Sizingforpropert
 • Attachingthetrackingunittotheclient
You will need both a standard and Phillips screwdriver to complete the
installation. Discard the locking pins after each use, and discard the
backplate after each battery replacement; locking pins and backplates are
available by order from BI Incorporated. All other supplies - including the
straps - are reusable and should not be discarded. Keep in mind that the
battery should be replaced after 2 years of continuous use.
•8-90-00130-0,RevisionA•3
Hinge Assembly
Fiber-Optic Connector