User Manual

Battery Cover
10•BIExacuTrackOneQuickInstallationGuide•8-90-00130-0,RevisionA
Step 1
Wrap the tracking unit
around the client’s ankle
as you did in step 1 of the
previous section.
Step 2
Align the hinge post with
the fiber-optic connector on
the fixed strap. Press firmly
on the fixed strap to hold
both straps in place.
ATTACHING: STEPS 14
When attaching the tracking unit to the client, keep the following
requirements in mind:
 •Thestrapsizingnumbersmustfaceoutward(awayfromtheleg).
 •Thetrackingunitmustbeintheuprightposition.
To Attach the Tracking Unit >
Fiber-Optic Connector
Step 8
Connect the backplate to
the back of the unit case,
ensuring the battery cover
slides into the groove on
the bottom of the unit case.
You will hear a distinct
click when the backplate is
properly attached.
Step 9
Place the unit upright on a
level, non-metallic surface.
Plug the power supply into
a wall outlet, and plug the
magnetic power adapter into
the charging port. Wait for an
audible tone (approximately
20 seconds). Once this tone
occurs, unplug the magnetic
power adapter. If all three LEDs
begin flashing, charge the unit
for a few minutes, and wait for
the tone. If you do not hear
an audible tone, reinstall the
battery and a new backplate,
and repeat this process.
Step 10
Assemble the male and
female hinges using the
locking pins. Pressing firmly,
insert a locking pin into
both sides of the hinge
assembly. The wing-tipped
ends of the locking pins
must be inserted first. This
piece is now referred to as
the hinge assembly.
•8-90-00130-0,RevisionA•7
Side 1 Side 2