User's Manual

ManualsBrandsSendum Wireless ManualsElectronicsTRANSMITTER BEACON FOR TRACKING OFFENDERS

The Beacon

Preface

BI ExacuTrack

One Officer’s Reference Guide

Printed in USA

BI prepared this guide for use by BI customers only. All comments concerning the contents of

this guide should be directed to BI’s Marketing Department, 6400 Lookout Road, Boulder, CO

80301, USA. No part of this work covered by copyright may be reproduced in any form either

graphically, electronically, mechanically; including photocopying, recording, taping, or storage

in an information retrieval system without prior written permission from BI.

Trademarks and Patents

The following are registered trademarks of BI Incorporated:

BI logo

BI ExacuTrack

BI ExacuTrack logo

Technical Support

For technical support when using BI’s monitoring center, contact the BI GuardCenter:

BI GuardCenter

800 Main Street, Suite 501

Anderson, Indiana 46016

1-800-666-3145

FAX 1-765-649-3148

For technical support when using an agency monitoring center, contact BI Incorporated:

BI Incorporated

6400 Lookout Road

Boulder, CO 80301

1-800-241-9924

Waste Electrical and Electronic Equipment (WEEE)

All electrical products that reach the duration of their functioning capabilities must be returned

to BI Incorporated for recycling.

Summary of content (6 pages)

PAGE 1
The Beacon Preface BI ExacuTrack® One Officer’s Reference Guide Copyright © 2009, BI Incorporated All Rights Reserved Printed in USA BI prepared this guide for use by BI customers only. All comments concerning the contents of this guide should be directed to BI’s Marketing Department, 6400 Lookout Road, Boulder, CO 80301, USA.
PAGE 2
United States FCC, Part 15 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications made by the user to this equipment that are not expressly approved by BI Incorporated could void the user’s authority to operate the equipment.
PAGE 3
Ministry of Health (Canada). Safety Code 6. Limits of Human Exposure to Radiofrequency Electromagnetic Fields in the Frequency Range from 3 kHz or 300 GHz, 1999. Australian Communications Authority Radiocommunications (Electromagnetic Radiation Human Exposure) Standard 2003. ANATEL, Brasil Regulatory Authority, Resolution 303 (July 2, 2002) “Regulation of the limitation of exposure to electrical, magnetic, and electromagnetic fields in the radio frequency range between 9 kHz and 300 GHz.
PAGE 4
Blasting Caps and Areas To avoid possible interference with blasting operations, turn off radio products when near electrical blasting caps, in a blasting area, or in areas posted: “Turn off two-way radio.” Obey all signs and instructions. The tracking unit operates in unison with up to three beacons that continuously send radio frequency (RF) signals to the tracking unit. The tracking unit then detects the signal, ultimately determining if a client is within the confinements of a residence.
PAGE 5
Motion Detection The beacon contains motion sensors inside the casing to deter the client from relocating the unit. If the client moves the beacon, it begins recording the amount of time the unit is in motion and starts transmitting a motion detection signal. Variable Leave Window When a client leaves the beacon’s range, he or she must be away for a specified amount of time before the tracking unit acknowledges a Leave event and begins searching for a location fix.
PAGE 6
• • • Do not place the beacon in front of a mirror. Do not place the beacon in direct sunlight. To install the beacon 1. Insert 2 standard D-Cell batteries into the bottom of the beacon. 2. Place the battery cover over the bottom of the beacon. 3. Secure the battery cover with the provided screw. 4. Place the beacon in the selected location. To remove the beacon 1. Remove the beacon from the client’s residence. 2. Remove the screw on the battery cover to remove the batteries. 3.