User Manual Sengled Bluetooth module ---------------------------------------------------------------------------- Module No.: BT004 Version: V1.0 Change History: Version Description V1.
Content 1 Introduction .......................................................................................................................... 3 2 Features ............................................................................................................................... 3 3 Applications .......................................................................................................................... 3 4 Electronic Specification.........................................................
1 Introduction BT004 intelligent lighting module is a Bluetooth low power module based on TLSR8253F512AT32 chip. The Bluetooth module with BLE and Bluetooth mesh networking function, Peer to peer satellite network communication, using Bluetooth broadcast for communication, can ensure timely response in case of multiple devices. It is mainly used in intelligent light control. It can meet the requirements of low power consumption, low delay and short distance wireless data communication.
Electronic Specification Item Min TYP Max Unit 6.0 8.0 10.0 dBm -92 -94 -96 dBm +/-10 +/-15 KHz RF Specifications RF Transmitting Power Level RF Receiver Sensitivity @FER<30.8%, 1Mbps RF TX Frequency tolerance RF TX Frequency range 2402 2480 MHz RF Channel CH0 CH39 / RF Channel Space 2 MHz AC /DC Characteristics 1.8 Operation Voltage Supply voltage 3.3 3.6 V 10 ms rise time （ from 1.6V to 2.8V） Input High Voltage 0.7VDD VDD V Input Low Voltage VSS 0.
Output Low Voltage VSS 0.1VDD V 5 Power Consumption Operation Mode Consumption TX current 4.8mA Whole chip with 0dBm RX current Standby (Deep Sleep) depend on firmware 5.3mA Whole chip 0.4uA (optional by firmware) 6 Antenna Specification ITEM UNIT MIN Frequency MHz 2400 TYP 2500 V.S.W.R 2.0 Gain(AVG) Maximum MAX dBi 1.0 input power W Radiated Pattern PCB antenna Omni-direc tional Impendence 50Ω Antenna type 1 OEM/Integrators Installation Manual 1.
antenna with max antenna gain 1.0dBi. If the antenna needs to be changed, the certification should be re-applied. 3.Limited module procedures NA 4.Trace antenna designs NA 5.RF exposure considerations This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .This equipment should be installed and operated with minimum distance 20cm between the radiator& your body. 6.Antennas Antenna type: PCB antenna;2.4GHz band Peak Gain: 1.0dBi 7.
that host product manufacturers should notassume that because the modular transmitter is certified that they do not have any responsibility for final product compliance. c)If the investigation indicates a compliance concern the host product manufacturer is obligated to mitigate the issue. Host products using a modular transmitter are subject to all the applicable individual technical rules as wellas to the general conditions of operation in Sections 15.5, 15.15, and 15.29 to not cause interference.
high duty cycle, such as by sending a file or streaming some media content. FCC Statement: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules.
