User Manual C01-BR30 LED Lamp LED + Wireless Audio System
Features • Install like any other light bulb. Enjoy the energy savings from LED and the audio quality of JBL speakers.
LED Lights • Power: 8 Watts • Luminance: 600 lumens • Colour Temperature: 2700K - Warm White • Light Beam Angle: 105 degrees Audio System Power: 13 Watts @ 8ohm 1.75’’ Full Range High Fidelity Loudspeaker Frequency Response: 100 Hz - 20 kHz System Wireless Point-to-Point Latency < 20ms Bluetooth Standard: v2.1 + EDR (Class 2) Bluetooth Transmitter Frequency Range: 2.402 - 2.480 GHz Bluetooth Profiles: A2DP, AVRCP, iAP, SPP etc.
INSTALLATION INSTRUCTIONS WARNING - TO REDUCE THE RISK OF FIRE AND ELECTRIC SHOCK, USE IN DRY LOCATIONS ONLY AND DO NOT EXPOSE TO RAIN OR LIQUIDS. WARNING - TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE BACK COVER OR TAKE APART. THERE ARE NO SERVICEABLE PARTS INSIDE. 1. Before installing the Pulse into an E26 light bulb socket, turn the light switch to the OFF position. (DO NOT USE WITH EXTERNAL OR OUTSIDE DIMMERS). 2. Screw the bulb into an E26 socket and turn the power on.
. Open the Pulse application, and a 'Welcome' page appears. The Pulse App will search and connect to bulb automatically. The wizard guides you through the steps for connecting your portable smart device to the Master bulb. If the application doesn't detect a Master bulb, restart the application and setup wizard again. 6. Once the portable device has been successfully connected to the Master bulb, the application will display the main control screen.
IMPORTANT SAFETY INSTRUCTIONS • • • • • • • • • • • • • Read and keep these safety instructions. Heed all warnings contained within these instructions. Please follow all user manual instructions when installing the product. Only clean SENGLED product only with a dry towel. This Product is intended for indoor use only. Do NOT use this product outdoors. Do NOT get this product wet and do NOT use near any water source. The product should not be exposed to dripping or splashing liquids of any kind.
• Do not block any ventilation openings on the product, as shown below. • Never push any objects into the openings or slots on the product. Doing so may create an electric shock or fire hazard. Maintain sufficient distance around your product for sufficient ventilation; do not put anything within at least 6 inches of light bulb socket. For best protection against lightning, unscrew the product from its power source during a storm. Only use accessories specifically recommended by the manufacturer.
CAUTION: WITHIN THE 5150 - 5250 MHZ BAND, INDOOR OPERATIONS ARE ONLY ALLOWED. NOT FOR USE IN EMERGENCY LIGHTING. DO NOT USE IN DAMP LOCATIONS. ENSURE FIXTURE CAN SUPPORT ADDED WEIGHT OF BULB. FCC STATEMENT FOR USERS This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. SECTION 15.
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT, SECTION 15.105(b) This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operated in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions to satisfy RF exposure compliance. © 2014 SENGLED, Incorporated. All rights reserved.
