User's Manual

ManualsBrandssengled ManualsElectronicsSengled Z-wave Module

Smart Z-wave Module User Manual

Introduction:

Smart Z-wave Module can be operated in any Z-Wave network with other Z-Wave

certified devices from other manufacturers. All non-battery operated nodes

within the network will act as repeaters regardless of vendor to increase

reliability of the network. (Certified Z-wave hub required).

Important Safety Information:

• Suitable for use in operating environment between -4°F and 104°F (-20°C and 40°C).

• Indoor use only.

Hardware Specifications

Wireless Protocol

Z-Wave

Radio Frequency

908.42MHz(US)

Maximum Transmitted Output Power

+10dBm

Antenna Information

Internal Antenna /0dBi

Communication Distance

Over 100m

Modulation Mode

FSK(BFSK/GFSK)

Voltage(V)

120V , 60Hz

Dimensions(mm)

20 mm *42mm

Wireless Specifications：

SDK Version

7.14.3

SDK Library

Flex 3.0.2.0

Explorer Frame Support

yes

Routing

yes

SmartStart

yes

Device Type

Multilevel Switch

Basic Device Class

Routing Slave

Generic Device Class

Switch Multilevel

Specific Device Class

Power Switch Multilevel

Role Type

Slave Always On

Installation Instructions(Add for inclusion):

Note: This Module can only work with a smart Z-wave hub.

Reset Instructions manually:

To reset your Device to factory mode, ensure that the module is on firstly, then quickly turn it

off and on at least 5 times (using a light switch or power bar works best). If the reset is

successful, the bulb will flash 3 times. If it does not flash 3 times, you will have to try again.

Once successfully reset, please try to pair it again.

Summary of content (4 pages)

PAGE 1
Smart Z-wave Module User Manual Introduction: Smart Z-wave Module can be operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network. (Certified Z-wave hub required). Important Safety Information: • Suitable for use in operating environment between -4°F and 104°F (-20°C and 40°C). • Indoor use only.
PAGE 2
FCC Certification Requirements. According to the definition of mobile and fixed device is described in Part 2.1091(b), this device is a mobile device. And the following conditions must be met: 1. This Modular Approval is limited to OEM installation for mobile and fixed applications only.
PAGE 3
If the device is used for other equipment that separate approval is required for all other operating configurations, including portable configurations with respect to 2.1093 and different antenna configurations. For this device, OEM integrators must be provided with labeling instructions of finished products. Please refer to KDB784748 D01 v07, section 8. Page 6/7 last two paragraphs: A certified modular has the option to use a permanently affixed label, or an electronic label.
PAGE 4
included in the manual in that alternative form, provided the user can reasonably be expected to have the capability to access information in that form. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.