User's Manual

Requirement per KDB996369 D03
2.2 List of applicable FCC rules
List the FCC rules that are applicable to the modular transmitter. These are the rules
that specifically establish the bands of operation, the power, spurious emissions, and
operating fundamental frequencies. DO NOT list compliance to unintentional-radiator
rules (Part 15 Subpart B) since that is not a condition of a module grant that is
extended to a host manufacturer. See also Section 2.10 below concerning the need to
notify host manufacturers that further testing is required.3
Explanation: This module meets the requirements of FCC part 15.247.
2.3 Summarize the specific operational use conditions
Describe use conditions that are applicable to the modular transmitter, including for
example any limits on antennas, etc. For example, if point-to-point antennas are used
that require reduction in power or compensation for cable loss, then this information
must be in the instructions. If the use condition limitations extend to professional users,
then instructions must state that this information also extends to the host
manufacturer’s instruction manual. In addition, certain information may also be
needed, such as peak gain per frequency band and minimum gain, specifically for
master devices in 5 GHz DFS bands.
Explanation: The EUT has a PCB Antenna, and the antenna use a permanently attached antenna which
is not replaceable.
2.4 Limited module procedures
If a modular transmitter is approved as a “limited module,” then the module
manufacturer is responsible for approving the host environment that the limited
module is used with. The manufacturer of a limited module must describe, both in the
filing and in the installation instructions, the alternative means that the limited module
manufacturer uses to verify that the host meets the necessary requirements to satisfy
the module limiting conditions.
A limited module manufacturer has the flexibility to define its alternative method to
address the conditions that limit the initial approval, such as: shielding, minimum
signaling amplitude, buffered modulation/data inputs, or power supply regulation. The
alternative method could include that the limited module manufacturer reviews
detailed test data or host designs prior to giving the host manufacturer approval.
This limited module procedure is also applicable for RF exposure evaluation when it is
necessary to demonstrate compliance in a specific host. The module manufacturer
must state how control of the product into which the modular transmitter will be
installed will be maintained such that full compliance of the product is always ensured.
For additional hosts other than the specific host originally granted with a limited
module, a Class II permissive change is required on the module grant to register the
additional host as a specific host also approved with the module.
Explanation: The module is not a limited module.