User's Manual

Local Operations

Reset the hub: The hub has to be reset when changing Wi-Fi

networks. Press and hold the white round button on the side of the

hub for at minimum eight seconds and then release it, the middle

blue signal indicator light on the front of the hub should flash eight

times if the reset is successful. Wait for up to 30 seconds for the

indicator light to steady.

Rejoin wireless network from the bulb: Power cycle the bulb (off

then back on) five times quickly. The bulb will blink two times

indicating network rejoin.

Reset factory default for the bulb: Power cycle the bulb (off then

back on) quickly for at minimum ten times. The bulb will blink five

times indicating pairing mode.

EZ-Mode commissioning from the bulb: Power cycle the bulb (off

then back on) seven times quickly to enable EZ-Mode. The bulb will

blink to indicate that it is in this mode for three minutes. To exit this

mode earlier, power off the bulb via the wall switch, wait for two

seconds and then power it back on.

Setting the bulb’s dim level via wall switch: Enable dimming by

powering the bulb off and then on within one second. The light will

gradually change from its current brightness setting to the

maximum. Following this, the brightness will change from the

maximum to the minimum and finally back to the maximum again.

When the brightness is changing, power off the bulb when the

bulb reaches the desired dim level. Power the bulb back on and the

bulb should now be set to the new dim level. If no power off action

is taken, the light will remain at maximum brightness level.

*To ensure the following steps work successfully, please power

on the bulb first and wait for at least four seconds before taking

any of the steps.