Product Info

Preparation
Installing/Removing the Antenna
Installing/Removing the Battery
Screw the antenna into
the connector on the top
of the transceiver by
holding the antenna at its
base and turning it
clockwise until secure.
Note: Turn the antenna
counter-clockwise until
you can remove it.
1.Attach the belt clip
above the correspond-
ing holes on the back of
the radio, and screw it
clockwise with the two
supplied screws.
2.Loosen the screws to
remove the belt clip.
1.Match the two top
grooves of the battery
pack on the back of the
radio and then push it.
2.Screw it clockwise to
install the battery.
3.Unscrew count-
er-clockwise to
remove the battery.
Installing/Removing the Belt Clip
2 53
4
0706
Before Use
Constant Red
Constant Green
Charging
Fully Charged
USB Charging
Battery LED Indicator and battery status
1.Plug the USB charging cable into the charging port
on the back of the battery.
2.The indicator light turns to red, the charging begins.
3.The indicator light turns to green, the charging is
completed.
Use only the USB charging cable specified by the
manufacturer. Charger LED can indicate the
charging status.
LED indication Charging status