Specifications

GPS TRACKER
DESCRIPTION
KRG GPS tracker is designed to
send geolocalized alerts.
GPS tracker is a fully supervised
low-current detector including an
advanced Sigfox protocol.
SET UP
To acvate the GPS Tracker, press
the buon during 1 to 2 seconds.
LED will blink as described below.
1. Red LED on the tracker ashing
every 1 second.
2. Green or red (depending on the
conguraon) LED lights on during
5 seconds.
3. The conguraon is set up.
When the device restarts aer a
hardware or soware reset or when
it is plugged to be recharged aer a
shutdown due to empty baery, it
will follow steps described before.
BATTERY CHARGE
1. Put the GPS tracker into the
cradle to charge it.
2. Green LED will start ashing
every 3 secondes.
3. When the green LED stops
ashing and is connously
turned on, the device is fully
charged (around 2h).
To indicate low
baery (<20%),
red LED will ash
every 10 seconds.
SEND AN ALERT
To send an alert, push buon during
1 to 2 seconds.
1. Green LED will ash every
second during 1 minute.
2. Green LED lights on during 3
seconds to indicate an alert is sent.
To cancel the alert, push the buon
in the following 30 seconds during
10 seconds without interrupon.
Green LED will stop ashing
to inidicate alert has been well
canceled.
DIMENSIONS
59,1 mm
59 mm
21,6 mm
SPECIFICATIONS
Sigfox Zone
RCZ1 (Europe)
RF Specicaon
Sigfox Class 0
Product Size
59,1mm(L) x 59mm(W) x 21,6mm(H)
Buon
One big button for emergency usage
LED
Dual color LED Green and Red
Connector
1. One MicroUSB connector for battery
charging
2. One cradle to charge easily the tracker
IP Rang
IP65
Baery
Rechargable lithium. Baery 3.8V 630mAh
Baery life
> 18 months
Operaon temperature
- 10 / +50c, 0-90% RH non-condensing
Storage temperature
- 20 / +70c, 0-90% RH non-condensing
Geolocaon
Geolocaon can not be fully guaranteed in
the following condions : indoor, in trac.