Instruction manual

SENKO cookers 2P extra rustik and glass – Instruction manual 36
7.2. FIRING REGIME SWITCH MECHANISM
Mechanism may become jammed during use due to solid ash debris,
metal parts (i.e. nails), feeding with inappropriate fuels, exceeding the
cooker nominal power. It is necessary
to remove and clean the mechanism
in those instances.
It is first necessary to check if only
the grate is jammed. Remove the
grate from the boiler and test the
mechanism. If the mechanism cannot
be launched at that point, it is
necessary to remove and clean it.
Mechanism is removed by removing the protective sheet above the
mechanism first and then by removing the 4 frontal screws, 4 rear-end
screws and 2 screws on each, left and right sides, all using an OK10
wrench; and finally, by removing the entire mechanism (figure 22). The
mechanism is cleaned from impurities and reassembled by reversing the
procedure.
7.3. OLD COOKER DISPOSAL
Once the cooker is no longer fit for use it must be delivered to an authorized
disposal service specialized in recycling this type of waste. It is forbidden
to dispose of the old cookers in the natural environment !
7.4. SPARE PARTS
Only original spare parts by the manufacturer are to be used. Should
non-original spare parts be used or should the repair be executed by an
unauthorized individual, the warranty will be void.
figure 22