User's Manual

Prepared by KM 11/2015 11 Patent pending
14407 Coil Plus Dr, Unit A | Plaineld, IL 60544
www.sennco.com | [e-mail]
815.577.3400 | Toll free 866.736.6261
Mon - Fri 9AM - 5PM CST
10. Pull the cable end up through the large hole in the cradle mounng plate.
11. Guide the cable into the slot on the center post of the cable mounng plate. Slowly allow the cable to retract unl the cable end rests on
the center post.
12. Find the AC power cable for the cradle and pull the barrel plug end up through the large hole in the cradle mounng plate.
13. Plug the cable into the power port on the boom of the cradle.
14. Guide the cable into the cable keeper.
19. There is a red LED on the boom of the cradle which will be lit when the cradle is receiving power. This LED is not visible when the cradle is
on the cradle mounng plate.
20. Repeat as necessary for addional cradles.
15. Make sure that the mouse hole is towards the back of the xture.
16. Place the cradle on top of the cradle mounng plate, oset slightly counterclockwise from center.
17. Turn the cradle clockwise unl it locks in place.
18. Find the two-prong end of the AC power cable, connect it to the cradle end, and plug the two-prong end into an outlet that has AC power
available.