User's Manual
Prepared 10/2016 12 Patent pending
14407 Coil Plus Dr, Unit A | Plaineld, IL 60544
www.sennco.com | techsupport@sennco.com
815.577.3400 | Toll free 866.736.6261
Mon - Fri 9AM - 5PM CST
Cradle mounng opon 2: Mounng plate using screws (no wedge)
1. Center the cradle mounng plate over the posion, at side down. The slot in the center post of the cradle mounng plate should be open
at the top and the large opening in the cradle mounng plate should be at the top le. Depending on your xture type you may need to drill
holes for the mounng screws.
2. Insert two appropriate length screws from the mounng kit.
3. Place a washer and nut on each screw underneath the xture.
4. Hold the nut securely with a wrench and use a screwdriver to ghten the screw. Be careful not to overghten. Repeat for the other screw.
Cradle mounng opon 3: Wedge using adhesive
1. Clean the boom of the wedge using an alcohol wipe. Dry with a clean cloth.
2. Remove the backing from one side the wedge adhesive.
3. Apply the adhesive to the boom of the wedge. Press rmly for 15 seconds for a stronger adhesive bond.
4. Using an alcohol wipe, clean the surface with the cradle will be placed. Dry with a clean cloth.
5. Remove the remaining backing from the adhesive.
6. Center the wedge over the posion. The lower side should be to the front. Press rmly for 15 seconds for a stronger adhesive bond.
7. Place the cradle mounng plate (at side down) over the wedge. The slot in the center post of the cradle mounng plate should be open at
the top and the large opening in the cradle mounng plate should be at the top le.
8. Insert the two 0.5” screws. Tighten down with a screwdriver. Be careful not to overghten.