User's Manual
Prepared 10/2016 13 Patent pending
14407 Coil Plus Dr, Unit A | Plaineld, IL 60544
www.sennco.com | techsupport@sennco.com
815.577.3400 | Toll free 866.736.6261
Mon - Fri 9AM - 5PM CST
Cradle mounng opon 4: Wedge using screws
1. Center the wedge over the posion. The lower side should be to the front.
2. Insert two appropriate length screws from the mounng kit. (Depending on your xture type you may need to drill holes for the mounng
screws.)
3. Place a washer and nut on each screw underneath the xture.
4. Hold the nut securely with a wrench and use a screwdriver to ghten the screw. Be careful not to overghten. Repeat for the other screw.
5. Place the cradle mounng plate (at side down) over the wedge. The slot in the center post of the cradle mounng plate should be open at
the top and the large opening in the cradle mounng plate should be at the top le.
6. Insert the two 0.5” screws. Tighten down with a screwdriver. Be careful not to overghten.
Cradle mounng opon 5: Above Counter Post
Cradle mounng opon 6: Display Circle
Refer to instrucon code 120-007
Refer to instrucon code 120-012